Integrating two RF application modes
I want to simulate a 3D waveguide geometry using 3D transient wave propagation mode of RF module. The input field at one of the far cross-sections is an eigen-mode of the waveguide. I create a...
View ArticleRe: Integrating two RF application modes
Hi, I have exactly the same problem as you had. Did you find a solution already?
View ArticleRe: Integrating two RF application modes
Yes, I think I did. What specifically you want to know and which version?
View ArticleRe: Integrating two RF application modes
Does the cross section of your waveguide include different subdomain with different material? I would like to know how to do it respectively in version 4.0 and version 3.5a. Did you do it similar to an...
View ArticleRe: Integrating two RF application modes
Well, waveguide adapter model mode is not sufficient in transient analysis in which you have to define the field variables manually. But the beginning steps are the same, first mode analysis, then set...
View ArticleRe: Integrating two RF application modes
Hi, I am usning COMSOL 4.0.I want to model electromagnetic waves model in 3D for heating purpose and see the effect on fluid.I can build the model by defining an Edge Current but I am not getting the...
View ArticleRe: Integrating two RF application modes
Hi, I have the same problem. I want to simulate a rib waveguide (as in the attached file) for a 3D model. The rib is a single TM mode with a neff=3.538. If I try to simulate the same structure in 3D...
View Article